Raised Loft BoardingStorage and Insulation, Not One or the Other
Here is the problem raised boarding solves. Current guidance puts around 270mm of insulation in a cold loft. A ceiling joist is often 100mm deep. Lay boards on the joists and you have 100mm of space for 270mm of insulation, so either the insulation gets squashed or it never goes in.
Raised boarding lifts the deck. Timber battens stand on the joists, the deck sits on the battens, and the insulation keeps its full loose depth in the space underneath. You store things on top and the insulation carries on working.
Get a Free Quote
How It Is Built
Battens run across the joists at a spacing the deck can span. Their height is set by the insulation depth you want underneath plus a little clearance, so nothing is pressed down even at the edges.
The deck is tongue-and-groove loft panel, fixed to the battens. Where the insulation is deeper, the battens are taller; where a loft has unusually shallow joists, the battens can also help spread load across more of them rather than concentrating it.
Around the hatch the deck is finished flush so there is nothing to trip on climbing in, and we leave clear access to anything that needs reaching.
Why It Is Worth the Difference
Standard boarding is cheaper, and in a loft that genuinely has very little insulation it may be the right answer. But in a loft that is insulated properly, flat boarding quietly undoes part of what the insulation was doing, and you will never see it happening.
Compressed mineral wool loses a large part of its effectiveness, because what does the insulating is the air trapped in it. Press it flat and that air is gone. We see this constantly in lofts boarded by a previous owner.
If you want storage and you want the loft insulated properly, raised boarding is the answer that does both.
Where It Is Especially Worth It
- Inter-war semis, which are common across north Birmingham and often have deeper, more closely spaced joists that take a raised deck well
- Bungalows, where the whole floor area sits under the roof, so insulation matters more and the storage is more useful
- Any loft being insulated and boarded at the same time, because doing both on one visit means paying once for the access
- Lofts already boarded flat, where lifting the deck and putting the insulation back properly is often simpler than people expect
Doing it in the right order
If you are having insulation and boarding done together, the order matters: insulation first, to full depth, then the battens and the deck over it. Done the other way round, the insulation has to be fed in sideways under a finished deck, which is slow and never as tidy.
Tell us on the quote form if you want both, and we will price them as one visit.
How high does the deck sit?+
High enough to clear the insulation depth you are having, plus clearance. In practice that is usually something in the region of 50 to 100mm above the joists. The quotation will say.
Does it reduce the headroom?+
By the height of the battens, yes. In most lofts that is not a problem, but if your loft is already tight we will measure what you will be left with and tell you before you commit.
Can you raise boarding that is already down?+
Often yes. The existing deck comes up, the insulation goes back to full depth, the battens go on and the deck goes back. Whether the old boards are reusable depends on how they were fixed.
Is it worth it for a small storage area?+
For a small area near the hatch, flat boarding over a shallow insulation zone is sometimes the sensible answer. We will tell you which we think fits your loft rather than defaulting to the more expensive option.
Get a Free Quote for Raised Boarding
